I picked this up on Freecycle a few years ago intending to put a node up, but never got around to it

If you can use it, let me know.

John K6JDS  jds@sutters.com Sunnyvale

I have just returned to the forum and noticed that there has been very little activity and even fewer updates..

Is this project dead? Has everyone moved to an alternative?

Hi,

I now have two Mesh Nodes setup and active here on the west coast of the UK Mainland (M3IRJ-1 & M3IRJ-2). If anyone from the USA is interested in helping to setup a Tunnel to the UK, I would be happy to hear from you.

73 de Gareth Rogers M3IRJ

Today I have installed Hamchat 0.1 on my Linksys. Install went fine, but when I try to browse to it using the specified link, all I see is a 404 error page.

The requested URL was not found on this server.404 Not Found.

Any assistance would be greatly appreciated.

73

Gareth Rogers M3IRJ

As a complete beginner, I have just purchased a WRT54GL v1.1 which already has already been flashed with OpenWrt Backfire 10.03.1 / LuCI 0.10.0 Release (0.10.0).

When I try to reflash it using the bbhn-3.1.0-wrt54g-2.4-squashfs.bin, the following error message is displayed, and nothing happens:

'The uploaded image file does not contain a supported format. Make sure that you choose the generic image format for your platform.'

Also, when I connect to the router, it is still on 192.168.1.1, and cannot be connected to using localnode:8080/.

Any help or advice on how to flash the router with the latest (supported for this model) firmware would be greatly appreciated.

I have an installed base of 1.0 nodes and wold like to add another node.

Thanks!

The email seems to be cancelled and the posts seem to be old.

I am trying to resuscitate some previous HSMM system I built several years ago.

Thanks!

I want to thank the people who wrote the software and the documentation.

I was able to install new firmware into my WRT54GL without any problems. It just plain worked like it was supposed to. I bought a second WRT54GL and installed it there as well, and each unit can see the other. 

My biggest problem now is that I'm too far away from anyone else here in the Charlotte, NC area, so my mesh is only my two nodes. I'll be ready when a neighbor sets one up.  

Thanks again for software and documentation that just plain worked.

de K4EGP

i have ipv4 169.254.209.180wifi and 169.254.171.52 but no default gateway can someone help no way to login thanks 

Hi all, I have a Ubiquiti Bullet M2 that was working fine  and after I selected the access point setting

I can't get back in. so far I have tried a pushing the reset switch under the bullet for 3-7 seconds

and try again to log in with the following http://localnode:8080 and no go,

also try to do a hard reset (more time holding the reset switch like 13-20 seconds)

and still no go. also try to Power off the bullet and hold the reset switch and power back on while holding

the reset switch and after waiting a while for the unit to come on the led lights keep flashing for a while

and then power off and back on and still no go, I think I did a hard reset to all the software but no go still.

can anyone help?

Thanks.

n6toc